LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-1529036.png)
tooth side). Then store them separately.
18. REMOVE REAR DIFFERENTIAL CASE BEARING
(a) Tighten SST bolt and push out the case bearing outer race on the ring gear back surface side.
SST : 09571-50010
NOTICE:
Do not drop the case bearing outer race.
HINT
*
For reassembly purposes, mark the installation positions of the differential case bearing outer race and differential side gear shaft
snap ring.
*
Place distinguishing marks on the left and right side differential case bearing outer races to distinguish them (back surface side,
tooth side). Then store them separately.
(b) Remove the 2 bolts and SST from the differential carrier.
19. REMOVE REAR DIFFERENTIAL CASE BEARING
(a) Raise the ring gear side of the differential case slightly and remove the ring gear tooth side case bearing outer race.
NOTICE:
Do not drop the case bearing outer race.
HINT
*
For reassembly purposes, mark the installation positions of the differential case bearing outer race and differential side gear shaft