LS 460 RWD V8-4.6L (1UR-FSE) (2010)
HINT
Use the side gear shaft snap ring that was used during the tooth contact adjustment.
(e) Loosen the thinnest side gear shaft snap ring on the ring gear tooth side.
(f) Tap the differential carrier on the ring gear tooth side using a plastic-faced hammer to stabilize the case bearing.
(g) Remove the 2 bolts and SST from the differential carrier.
35. ADJUST DIFFERENTIAL DRIVE PINION PRELOAD
(a) Using SST and a torque wrench, measure the preload.
SST : 09229-55010
Standard total preload (at starting):