LS 460 RWD V8-4.6L (1UR-FSE) (2010)
43. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(a) Remove the differential carrier from the overhaul attachment.
44. INSTALL REAR DIFFERENTIAL BREATHER PLUG OIL DEFLECTOR
(a) Clean the seal packing attached on the differential carrier and carrier cover using a scraper and wire brush. Then remove the oil with a
non-residue solvent or equivalent.
NOTICE:
Do not scratch the fitting surface.
(b) Install the rear differential breather plug oil deflector to the rear differential carrier cover with the bolt.
Torque : 7.0 Nm (72 kgf-cm, 62 in-lbf)
45. INSTALL REAR DIFFERENTIAL CARRIER COVER
(a) Apply seal packing to the differential carrier as shown in the illustration.
Seal packing:
Toyota Genuine Seal Packing 1281, Three bond 1281 or equivalent
NOTICE:
*
Apply the seal packing in a continuous line, approximately 2 to 3 mm (0.08 to 0.12 in.) in diameter.
*
Overlap the seal packing at least 10 mm at the beginning and the end of application.
*
Install the differential carrier cover within 3 minutes of application.