LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-1532002.png)
NOTICE:
*
Make sure the mount cushion installation angle misalignment is not over +-3.
*
Make sure the mount cushion is not at an angle by first temporarily installing the mount cushion to the member before installing
SST.
*
Before using SST bolt, apply hypoid gear oil to their threads.
*
Be sure to combine SST properly.
*
Confirm that SST contacts the entire seat surface of the mount cushion.
*
Do not install SST bolts at an angle.
3. REMOVE REAR SUSPENSION MEMBER DAMPER
(a) Install the rear suspension member damper with the 3 bolts.
Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)
4. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
(a) Support the rear suspension member with an engine lift and attachments.
CAUTION:
*
As the rear suspension member is very heavy, securely support it with an engine lifter with attachments.
*
Perform this procedure with several people supporting the rear suspension member so that it does not tilt or fall.
(b) Slowly raise the engine lift so that the rear suspension member is at its installation position.
(c) For Normal Package
(1) Install the 2 rear suspension member stopper lowers, and the 2 differential support member stopper lowers with the 4 bolts.
Torque : 127 Nm (1300 kgf-cm, 94 ft-lbf)
(d) For Sports Package
(1) Install the 2 rear suspension member stopper lower LH and RH, and the 2 differential support member stopper lowers with the 8 bolts.
A - Torque : 127 Nm (1300 kgf-cm, 94 ft-lbf)
