LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. REMOVE ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
5. REMOVE ENGINE ROOM SIDE COVER RH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
6. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
7. REMOVE COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Cooling System/Radiator/Service and Repair/Removal
8. REMOVE RADIATOR GRILLE ASSEMBLY See: Body and Frame/Grille/Service and Repair/Removal
9. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH
10. REMOVE FRONT FENDER WHEEL OPENING MOULDING RH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
11. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
12. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
13. REMOVE FRONT FENDER LINER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
14. REMOVE FRONT FENDER LINER RH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
15. REMOVE FRONT BUMPER COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
16. REMOVE NO. 4 ENGINE ROOM WIRE
(a) Disconnect the sensor connectors.
(b) Detach the claws, and remove the wire harness together with the clips from the sensors.
(c) Remove the tape and wire harness (with the clips) from the bumper cover.
(d) Remove the clamps from the clips to remove the wire.