LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization).
4. REMOVE BATTERY SERVICE HOLE COVER
5. REMOVE ROPE HOOK
6. REMOVE ROPE HOOK ASSEMBLY
7. REMOVE DECK TRIM SIDE BOARD RH
8. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
9. REMOVE NO. 1 COOLER COVER (w/ Rear Cooler) See: Heating and Air Conditioning/Housing Assembly HVAC/Service and Repair/Air
Conditioning Unit (for Rear Side)/Installation
10. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
11. REMOVE REAR FLOOR FINISH PLATE
12. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH
13. REMOVE TRUNK LID ACTUATOR
(a) Disconnect the connector.
(b) Remove the 3 bolts and nut.
(c) Remove the trunk lid actuator.
Installation
ENGINE HOOD / DOOR: TRUNK LID ACTUATOR: INSTALLATION
INSTALLATION
1. INSTALL TRUNK LID ACTUATOR
(a) Install the trunk lid actuator with the 3 bolts and nut.
Torque: 5.5 Nm (55 kgf-cm, 49 in-lbf)
(b) Connect the connector.
2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH
3. INSTALL REAR FLOOR FINISH PLATE
4. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER