LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(5) Turn the power switch ON (IG). Reading the value of the stroke sensor shown on the data monitor, turn the sensor slowly to the right and
left to adjust the output voltage to the standard voltage.
Standard voltage:
(6) Tighten the 2 bolts.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not depress the brake pedal after turning the power switch ON (IG).
(7) Disconnect the cable from the negative battery terminal.
(8) Disconnect the intelligent tester or Techstream.
2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Side Knee
Airbag Assembly/Installation
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
4. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
5. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
6. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Installation
7. INSTALL STEERING COLUMN COVER (w/o Driver Monitor Camera) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Installation
8. INSTALL STEERING COLUMN COVER (w/ Driver Monitor Camera) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Installation
9. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Installation
10. INSTALL INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation