LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
18. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
19. REMOVE BATTERY SERVICE HOLE COVER
20. REMOVE SERVICE PLUG GRIP See: Hybrid Drive Systems/Battery System, Hybrid Drive/Hybrid Battery Service Switch/Service and
Repair/Removal
21. DISCONNECT NO. 1 MOTOR COOLING PIPE See: Antilock Brakes / Traction Control Systems/Electronic Brake Control Module/Service and
Repair/Removal
22. REMOVE SKID CONTROL ECU See: Antilock Brakes / Traction Control Systems/Electronic Brake Control Module/Service and
Repair/Removal
23. DISCONNECT NO. 3 RELAY BLOCK
(a) While pushing the claw of the No. 3 relay block, pull out the No. 3 relay block and disconnect it from the reservoir bracket.
NOTE: Do not allow brake fluid to contact the No. 3 relay block.
24. REMOVE BRAKE FLUID RESERVOIR See: Brake Master Cylinder/Service and Repair/Removal
25. REMOVE SKID CONTROL ECU BRACKET See: Antilock Brakes / Traction Control Systems/Electronic Brake Control Module/Service and
Repair/Removal
26. REMOVE NO. 1 RESERVOIR HOSE See: Brake Master Cylinder/Service and Repair/Removal
27. REMOVE RESERVOIR BRACKET See: Brake Master Cylinder/Service and Repair/Removal
28. REMOVE FRONT WHEEL
29. DISCONNECT BRAKE TUBE
(a) Release the lock lever and disconnect the brake actuator connector.
NOTE: Do not allow brake fluid to contact the connector face.