LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Cruise Control Switch: Service and Repair
Removal
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: REMOVAL
REMOVAL
1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
2. REMOVE BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
NOTICE:
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. REMOVE SWITCH AND VOLUME CASE See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Removal
5. REMOVE LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Removal
6. REMOVE STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Removal
7. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY
(a) Disconnect the connector and clamp.
(b) Remove the 2 screws.