LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
2. REMOVE COWL SIDE TRIM BOARD LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE DASH PANEL EXTENSION LH
(a) Detach the clamp.
(b) Disconnect the connector.
(c) Remove the 2 nuts, bolt and dash panel extension.
4. REMOVE DRIVING SUPPORT ECU
(a) Remove the nut and ECU.
NOTICE:
-
Do not drop the ECU or subject it to strong shocks.
-
During the removal and installation, do not remove the drip-proof cover.
Installation
CRUISE CONTROL: DRIVING SUPPORT ECU: INSTALLATION
INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. INSTALL DRIVING SUPPORT ECU
(a) Install the ECU with the nut.
NOTICE:
-
Do not use an ECU which has been dropped or subjected to any strong shocks.
-
During the removal and installation, do not remove the drip-proof cover.
-
When a new ECU is installed, perform initialization.