LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(f) Remove the oil filter element and O-ring from the oil filter cap.
NOTE: Be sure to remove the cap's O-ring by hand, without using any tools, to prevent damage to the cap's O-ring groove.
4. INSTALL OIL FILTER ELEMENT
(a) Clean the inside of the oil filter cap, its threads and O-ring groove.
(b) Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap.
(c) Set a new oil filter element to the oil filter cap.
(d) Remove any dirt or foreign matter from the installation surface of the engine.
(e) Apply a small amount of engine oil to the O-ring again and temporarily install the oil filter cap.
(f) Using SST, tighten the oil filter cap.
SST: 09228-06501
Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
-
Do not remove the oil filter bracket clip.
-
Make sure that the oil filter is installed securely as shown in the illustration.
-
Be careful that the O-ring does not get caught between any surrounding parts.
(g) Apply a small amount of engine oil to a new drain plug O-ring, and install it to the oil filter cap.
NOTE: Before installing the O-ring, remove any dirt or foreign matter from the installation surface of the oil filter cap.
(h) Install the oil filter drain plug.