LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Oil Level Sensor: Service and Repair
Removal
2UR-FSE LUBRICATION: OIL LEVEL SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
2. REMOVE SERVICE PLUG GRIP See: Hybrid Drive Systems/Battery System, Hybrid Drive/Hybrid Battery Service Switch/Service and
Repair/Removal
3. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
(a) Remove the timing chain cover See: Engine Lubrication/Oil Pump/Service and Repair/Removal.
4. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY See: Transmission and Drivetrain/Differential Assembly/Differential
Carrier/Service and Repair/Removal and Replacement/Front Differential Carrier Assembly/Removal
5. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
6. REMOVE NO. 1 OIL PAN SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
7. REMOVE NO. 2 OIL PAN BAFFLE PLATE
(a) Remove the 4 bolts and baffle plate.
8. REMOVE ENGINE OIL LEVEL SENSOR
(a) Remove the 4 bolts and oil level sensor.