lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Electrical - HV and Auxiliary Battery Maintenance|Page 3892 > < Electrical - HV and Auxiliary Battery Maintenance|Page 3890
Page 3
background image

7.

Charge the 12-volt auxiliary battery using the GR8 Battery Diagnostic Station (SST P/N 00002-MCGR8).

A.

Connect the red charger clamp to the positive (+) battery terminal and the black charger clamp to the negative (-) battery terminal.

B.

Plug the charger into a grounded 110-volt nominal outlet and flip the power switch to the "ON" position.

C.

Once the charger is properly turned ON, perform a diagnostic charge by "MODEL" (LS 600h).

The GR8 Battery Diagnostic Station will indicate result when complete.

NOTE:

^

If the auxiliary battery was stored at 32°F (0°C) or below, charge the auxiliary battery in a room above 32°F (0°C).

CAUTION:

^

Charge in a well-ventilated area.

^

Do NOT allow sparks or fire near the auxiliary battery.

If the GR8 Battery Diagnostic Station is NOT available, you may charge the 12-volt battery by turning the vehicle on to "READY."

^

Run time will vary depending on the state of charge.

^

If this method is used, you must confirm that the battery is charged to 12.8 volts using a DVOM.

8.

After charging the auxiliary battery, install the positive (+) terminal cover.

9.

Install the left side inner trim cover and insert the clip.

10.

Close the trunk lid.

To Store for 30 Days or More

Disconnect the negative (-) terminal:

1.

Turn OFF all lights, accessories, and the hybrid system.

2.

Open the trunk lid.

Electrical - HV and Auxiliary Battery Maintenance|Page 3892 > < Electrical - HV and Auxiliary Battery Maintenance|Page 3890