LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-1065014.png)
(a) Connect the motor cable to the inverter with converter assembly.
(b) Secure the motor cable to the inverter with converter assembly with the 5 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
NOTICE:
-
When installing the bolts that secure the cable, do not damage anything inside the inverter with converter assembly.
-
Make sure that no foreign matter is present on the terminal block.
-
Be sure to tighten the bolt to the specified torque. Failure to do so may damage the bolt.
(c) Install the motor cable bracket with the 3 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
12. INSTALL INVERTER TERMINAL COVER
CAUTION: Wear insulating gloves.
(a) Set the inverter terminal cover to the inverter with converter assembly.
-
Check that the sealing rubber is securely installed to the inverter terminal cover before installing the cover.
-
Making sure that there are no foreign objects on the waterproofed parts before installing the inverter terminal cover.
-
Install the inverter terminal cover while inserting the guide pins on the both sides of the cover into guide pin holes of the inverter case.
-
When removing the inverter terminal cover, do not bend the connector terminals around the interlock part.
(b) Push in both ends of the inverter terminal cover horizontally by hand.
NOTICE:
-
Insert the inverter terminal cover horizontally to prevent it from tilting. Failure to do so may damage the inverter terminal cover guide pins.
-
Make sure that both the inverter terminal cover bolt holes are aligned and in contact with the holes in the inverter case.
(c) Secure the inverter terminal cover to the inverter with converter assembly with the 2 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
13. INSTALL CONNECTOR COVER ASSEMBLY
CAUTION: Wear insulating gloves.
