LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
REPLACEMENT
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
3. REMOVE FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Removal
4. REMOVE FRONT AXLE HUB BOLT LH
(a) Using SST, remove the front axle hub bolt.
SST: 09650-17011
NOTE: Do not damage the threads of the hub bolts.
5. INSTALL FRONT AXLE HUB BOLT LH
NOTICE:
-
Do not damage the threads of the hub bolts.
-
Install nuts to prevent damage to the hub bolts.
(a) Install a washer and nut to a new hub bolt as shown in the illustration.
(b) Using a screwdriver or an equivalent to hold the hub, turn the nut to pull the hub bolt until the bottom surface of the hub bolt head touches the
axle hub.
6. INSTALL FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Installation
7. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
8. INSTALL FRONT WHEEL
Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)