LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Standard resistance:
NG -- REPAIR OR REPLACE DISPLAY AND NAVIGATION OR MULTI-DISPLAY BRANCH WIRE OR CONNECTOR
(CANH, CANL)
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION OR MULTI-DISPLAY - BATTERY AND BODY GROUND)
(a) Connect the cable to the negative (-) battery terminal.
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
(b) Disconnect the L59 display and navigation (multi-display) connectors.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
(d) Measure the voltage according to the value(s) in the table below.
Standard voltage:
Result
D -- REPAIR OR REPLACE HARNESS OR CONNECTOR
C -- REPLACE MULTI-DISPLAY
B -- REPLACE MULTI-DISPLAY
A -- REPLACE DISPLAY AND NAVIGATION ASSEMBLY
Hybrid Vehicle Control ECU Communication Stop Mode
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Hybrid Vehicle Control ECU Communication Stop Mode
Hybrid Vehicle Control ECU Communication Stop Mode