LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
REMOVAL
HINT: When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.
1. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
(a) Disconnect the sensor connector.
(b) Using SST, remove the sensor from the front exhaust pipe.
SST: 09224-00010
2. REMOVE FRONT DOOR SCUFF PLATE RH
(a) Remove the front door scuff plate RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
3. REMOVE COWL SIDE TRIM BOARD RH
(a) Remove the cowl side trim board RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal.
4. REMOVE FRONT FLOOR SILENCER PAD RH
5. REMOVE REAR NO. 2 AIR DUCT
6. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
(a) Interior Side:
Disconnect the sensor connector.
(b) Exterior Side:
(1) Remove the grommet.
(2) Using SST, remove the sensor from the front exhaust pipe.
SST: 09224-00010
Installation
2UR-FSE ENGINE CONTROL SYSTEM: HEATED OXYGEN SENSOR: INSTALLATION
INSTALLATION
HINT: When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.