LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Evaporative Emission Control Canister: Service and Repair
Removal
2UR-FSE EMISSION CONTROL: CANISTER: REMOVAL
REMOVAL
1. REMOVE FLOOR NO. 1 UNDER COVER
(a) Remove the 2 hole plugs.
(b) Remove the 5 nuts, 5 clips and under cover.
2. REMOVE CANISTER
(a) Disconnect the fuel tank vent hose from the clamp labeled A shown in the illustration.
(b) Disconnect the air inlet line hose (connected to the leak detection pump) labeled B from the air inlet line tube shown in the illustration.
(c) Disconnect the purge line hose labeled C shown in the illustration form the pipe.
(d) Remove the 4 bolts, 2 plastic nuts and canister.
(e) Using a clip remover, detach the 2 wire harness clamps.
(f) Disconnect the leak detection pump connector.