LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Fuel Pressure Sensor/Switch: Service and Repair
Installation
2UR-FSE FUEL: FUEL PRESSURE SENSOR: INSTALLATION
INSTALLATION
1. INSTALL FUEL PRESSURE SENSOR
(a) Install a new gasket to the sensor.
(b) Using SST, install the sensor to the fuel delivery pipe.
SST: 09922-10010
without SST - Torque: 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)
-
Do not apply oil to threads of the pressure sensor and delivery pipe.
-
Do not allow foreign matter to enter the pipe during the installation.
-
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.).
-
Make sure SST and the torque wrench are connected in a straight line.
(c) Connect the sensor connector.
2. INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY See: Fuel Injector/Service and Repair/Fuel Injector (for Direct Injection)/Installation
3. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation.
4. INSPECT FOR FUEL LEAK See: Testing and Inspection