LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(a) Interior Side:
(1) Disconnect the sensor LH and RH connector.
(b) Exterior Side:
(1) Disconnect the 2 grommets.
(2) Disconnect the wire harness from the clamp on the LH and RH side.
(3) Using a union nut wrench, remove the 4 sensors.
NOTICE:
-
When removing the sensor, place a union nut wrench within the 16 mm (0.630 in.) area A shown in the illustration to avoid deformation of
the hexagonal part.
-
When removing/installing the grommet and sensor, be careful not to twist the wire and do not apply tension to the accessories.
-
If oil, etc. enters the sensor's connector, do not use it.