LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Transmission Position Switch/Sensor: Service and Repair
Installation
L110F HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL PARK/NEUTRAL POSITION SWITCH
(a) Install the park/neutral position switch to the hybrid vehicle transmission assembly.
(b) Temporarily install the 2 bolts.
HINT: Fully tighten the bolts with the neutral alignment mark line aligned with the groove. [*1]
(c) Install a new lock washer and the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 in-lbf)
(d) Temporarily install the control shaft lever with the nut.
HINT: Bend the tabs of the lock washer before fully tightening the nut. [*2]
(e) Turn the control shaft lever counterclockwise until it stops. Next, turn the control shaft lever clockwise 2 notches to set it to the N position.