LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
-
When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the driver side knee airbag.
-
The driver side knee airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
-
Use gloves and safety glasses when handling a driver side knee airbag with a deployed airbag.
-
Do not apply water to a driver side knee airbag assembly with a deployed airbag.
-
Always wash your hands with water after completing the operation.
-
An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with bare hands
to discharge static electricity before performing this procedure.
1. DISPOSE OF DRIVER SIDE KNEE AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE)
HINT: Prepare a battery as the power source to deploy the airbag.
(a) Check the function of SST See: Testing and Inspection/Initial Inspection and Diagnostic Overview/How To Proceed With Troubleshooting.
(b) Read the precaution See: Service Precautions.
(c) Disconnect the cable from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
NOTICE:
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
(d) Remove the driver side knee airbag See: Driver Side Knee Airbag Assembly/Removal.
(e) Install SST.
(1) Connect SST connector to the driver side knee airbag.
SST: 09082-00700
SST: 09082-00780
NOTE: To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock.
(2) Install the driver side knee airbag See: Driver Side Knee Airbag Assembly/Removal.
NOTE: Take care not to damage SST wire harness.
(3) Move SST at least 10 m (32.8 ft.) away from the vehicle front side window.
(4) Maintaining enough clearance for SST wire harness in the front side window, close all doors and windows of the vehicle.
NOTE: Take care not to damage SST wire harness.