LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-2616006.png)
(a) Remove the front seat outer belt.
(1) Wind the seat belt with the retractor.
(2) When the seat belt is sufficiently wound, cut the seat belt approximately 100 mm (0.393 in.) from the retractor, as shown in the illustration.
HINT: The seat belt is designed so that winding the seat belt before pretensioner activation will decrease the pulling power of the seat belt
during pretensioner activation.
(b) Check if SST is functioning properly.
SST: 09082-00700
SST: 09082-00770
CAUTION: When activating a seat belt pretensioner, always use the specified SST.
(c) Prepare SST for activation of the seat belt pretensioner.
(1) Connect SST (A) to SST (B). Then connect SST (B)'s connector to the seat belt pretensioner.
NOTE: To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock.
(2) Place the front seat outer belt on the ground and cover it with a tire (with wheel).
NOTE: Set up the front seat outer belt as shown in the illustration.
