LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
2. REMOVE BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
4. REMOVE BATTERY SERVICE HOLE COVER
5. REMOVE SERVICE PLUG GRIP See: Sensors and Switches - Hybrid Drive/Hybrid Battery Service Switch/Service and Repair/Removal
6. REMOVE ROPE HOOK
7. REMOVE ROPE HOOK ASSEMBLY
8. REMOVE DECK TRIM SIDE BOARD RH
9. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
10. REMOVE NO. 1 COOLER COVER (w/ Rear Cooler) See: Heating and Air Conditioning/Housing Assembly HVAC/Service and Repair/Air
Conditioning Unit (for Rear Side)/Removal
11. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
12. REMOVE REAR FLOOR FINISH PLATE
13. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH
14. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH
15. REMOVE REAR WHEEL
16. REMOVE SKID CONTROL SENSOR WIRE
(a) Disconnect the sensor connector.