LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
29. INSTALL COOLING BOX ASSEMBLY
(a) Install the cooling box with the 6 bolts.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
NOTE: Do not damage the packing.
(b) Connect the connector.
30. INSTALL REAR SEAT ASSEMBLY (for Power Seat)
(a) Install the rear seat assembly See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Power Seat)/Installation.
31. INSTALL REAR SEAT ASSEMBLY (for Ottoman)
(a) Install the rear seat assembly See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Ottoman)/Installation.
32. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)
(a) Install the rear seat assembly See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Fixed Seat Type)/Installation.
33. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
34. INSTALL BATTERY SERVICE HOLE COVER LH
35. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
36. ADD COMPRESSOR OIL
37. CHARGE REFRIGERANT
38. WARM UP ENGINE
39. CHECK FOR REFRIGERANT GAS LEAK See: Heating and Air Conditioning/Service and Repair
40. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.
Disassembly
AIR CONDITIONING: REAR EVAPORATOR TEMPERATURE SENSOR: DISASSEMBLY
DISASSEMBLY
1. REMOVE AIR DUCT LH
(a) Remove the 2 screws and duct.