LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-2201003.png)
(c) Using a screw extractor, remove the 2 bolts and steering lock actuator assembly from the steering column assembly.
3. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
(a) Disconnect the ECU connector.
(b) Remove the 2 screws and ECU.
Installation
STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU: INSTALLATION
INSTALLATION
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a) Install the ECU with the 2 screws.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
(b) Connect the ECU connector.
NOTE: The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape. When installing them,
connect the connectors of the same color.
2. INSTALL STEERING LOCK ACTUATOR ASSEMBLY
(a) Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.
