LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(a) Install the bracket with the 2 bolts.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
(b) Install the reservoir with the 2 nuts.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
3. INSTALL AIR CLEANER ASSEMBLY RH See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Installation
4. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY
(a) Install the inlet cover with the 5 clips.
5. INSTALL ENGINE ROOM SIDE COVER
(a) Install the side cover with the 4 clips.
6. INSTALL SERVICE PLUG GRIP
7. INSTALL BATTERY SERVICE HOLE COVER See: Hybrid Drive Systems/Battery System, Hybrid Drive/Hybrid Battery Service Switch
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
9. INSTALL BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
11. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION
(a) Perform variable gear ratio steering system calibration See: Sensors and Switches - Steering/Steering Angle Sensor/Testing and
Inspection/Variable Gear Ratio Steering System.