LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
6. INSTALL FRONT SUSPENSION MEMBER BRACKET SUB-ASSEMBLY RH
(a) Install the front bracket with the 4 bolts.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
7. INSTALL FRONT SUSPENSION MEMBER BRACKET SUB-ASSEMBLY LH
(a) Install the front suspension member bracket with the 4 bolts.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
8. INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal
and Replacement/Engine Assembly/Installation
9. INSTALL NO. 2 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
10. INSTALL NO. 1 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
11. INSTALL FRONT WHEELS
Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)
12. INSTALL SERVICE PLUG GRIP
13. INSTALL BATTERY SERVICE HOLE COVER See: Hybrid Drive Systems/Battery System, Hybrid Drive/Hybrid Battery Service Switch
14. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
16. INSTALL BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
17. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
18. CHECK SUSPENSION CONTROL SYSTEM
(a) Check suspension control system See: Suspension/Adjustments.
19. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust front wheel alignment See: Alignment/Service and Repair/Front Wheel Alignment.
20. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust headlight assembly See: Lighting and Horns/Headlamp/Adjustments/Headlight Assembly (for HID Headlight).
21. ADJUST OBJECT RECOGNITION CAMERA
(a) Adjust object recognition camera See: Cruise Control/Adjustments.
22. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.
23. INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT