LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
22. REMOVE ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
23. REMOVE FRONT SHOCK ABSORBER CAP LH See: Suspension Strut / Shock Absorber/Service and Repair/Front Shock Absorber/Removal
24. REMOVE ABSORBER CONTROL ACTUATOR See: Suspension Strut / Shock Absorber/Service and Repair/Front Shock Absorber/Removal
25. REMOVE FRONT PNEUMATIC SHOCK ABSORBER WITH CYLINDER ASSEMBLY LH See: Suspension Strut / Shock Absorber/Service
and Repair/Front Shock Absorber/Removal
26. REMOVE FRONT PNEUMATIC CYLINDER O-RING LH See: Suspension Strut / Shock Absorber/Service and Repair/Front Shock
Absorber/Removal
27. REMOVE INNER NO. 1 ARM ATTACHMENT PLATE LH
(a) Remove the 3 bolts and inner No. 1 arm attachment plate LH.
28. REMOVE INNER NO. 2 ARM ATTACHMENT PLATE LH
(a) Remove the 2 bolts and inner No. 2 arm attachment plate LH.
29. REMOVE FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH
(a) Remove the bolt and nut, and then remove the front No. 1 suspension upper arm assembly LH from the inner No. 1 arm attachment plate LH.
30. REMOVE FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH
(a) Remove the bolt and nut, and then remove the front No. 2 suspension upper arm assembly LH from the inner No. 2 arm attachment plate LH.
Installation
SUSPENSION: FRONT UPPER SUSPENSION ARM: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. TEMPORARILY INSTALL FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH