LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(a) Temporarily install the control arm with the bolt, nut and washer to the suspension member.
(b) Install the stud of the control arm, and temporarily install a new nut to the axle carrier.
HINT: Push the axle carrier downward.
5. TIGHTEN REAR UPPER NO. 2 CONTROL ARM ASSEMBLY LH
(a) Tighten the nut on the rear control arm.
Torque: 225 Nm (2294 kgf-cm, 166 ft-lbf)
(b) Tighten the nut on the rear control arm.
Torque: 160 Nm (1632 kgf-cm, 118 ft-lbf)
6. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Rear Lower Arm/Installation
7. CONNECT TOE CONTROL LINK SUB-ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
8. CONNECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear
Brake/Installation
10. STABILIZE SUSPENSION See: Suspension Strut / Shock Absorber/Service and Repair/Rear Shock Absorber/Installation