LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(a) Install the front suspension member bracket with the 4 bolts.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
10. TEMPORARILY INSTALL FRONT STABILIZER BAR (w/o Active Stabilizer) See: Stabilizer Bar/Service and Repair/Front Stabilizer
Bar/Installation
11. TEMPORARILY INSTALL FRONT ACTIVE STABILIZER CONTROL ACTUATOR ASSEMBLY (w/ Active Stabilizer) See: Suspension
Control ( Automatic - Electronic )/Damping Control Actuator/Service and Repair/Front Active Stabilizer Control Actuator/Installation
12. TIGHTEN FRONT NO. 1 STABILIZER BRACKET LH
(a) Tighten the front No. 1 stabilizer bracket LH with the 2 bolts.
Torque: 95 Nm (969 kgf-cm, 70 ft-lbf)
13. TIGHTEN FRONT NO. 1 STABILIZER BRACKET RH
(a) Tighten the front No. 1 stabilizer bracket RH with the 2 bolts.
Torque: 95 Nm (969 kgf-cm, 70 ft-lbf)
14. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the front stabilizer link with the 2 nuts.
Torque: 85 Nm (867 kgf-cm, 63 ft-lbf)
HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
15. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Install the RH side following the same procedures as the LH side.