LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
4. REMOVE SERVICE PLUG GRIP See: Hybrid Drive Systems/Battery System, Hybrid Drive/Hybrid Battery Service Switch/Service and
Repair/Removal
5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
6. REMOVE ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
7. REMOVE ENGINE ROOM SIDE COVER RH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
8. REMOVE COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Cooling System/Radiator/Service and Repair/Removal
9. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH
10. REMOVE FRONT FENDER WHEEL OPENING MOULDING RH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
11. REMOVE RADIATOR GRILLE ASSEMBLY See: Body and Frame/Grille/Service and Repair/Removal
12. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
13. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
14. REMOVE FRONT FENDER LINER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
15. REMOVE FRONT FENDER LINER RH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
16. REMOVE FRONT BUMPER COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
17. REMOVE NO. 1 ENGINE UNDER COVER
(a) Remove the 9 screws, 7 clips and under cover.
18. DISCONNECT FRONT FENDER LINER LH
(a) Remove the 3 screws.
(b) Partially remove the fender liner.
HINT: It is not necessary to fully remove the fender liner. Partially remove it so that the ECU can be removed.