LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Suspension Main Relay: Testing and Inspection
SUSPENSION CONTROL: SUSPENSION CONTROL RELAY: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
2. REMOVE BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
4. REMOVE SUSPENSION CONTROL RELAY (AIR SUS)
(a) Remove the suspension control relay from the engine room No. 5 relay block.
5. INSPECT SUSPENSION CONTROL RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
If the result is not as specified, replace the suspension control relay.
6. INSTALL SUSPENSION CONTROL RELAY
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.6 Nm (57 kgf-cm, 50 in-lbf)
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
8. INSTALL BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
9. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
10. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.