LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-2311001.png)
Stabilizer Bar: Testing and Inspection
Front Stabilizer Bar
SUSPENSION: FRONT STABILIZER BAR: INSPECTION
INSPECTION
1. INSPECT FRONT STABILIZER LINK ASSEMBLY
(a) Flip the ball joint stud back and forth 5 times as shown in the illustration.
(b) Temporarily install the nut, and use a torque wrench to turn the nut continuously at a rate of 2 to 4 seconds per turn. Take the torque reading on
the 5th turn.
Standard turning torque:
1.96 N*m (20 kgf*cm, 17.3 in.*lbf) or less
If the value is not within the specified range, replace the front stabilizer link assembly.
(c) Check the dust boot for cracks or grease leakage.
