LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
-
After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.
4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
5. REMOVE INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
6. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal
7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Side Knee
Airbag Assembly/Removal
10. REMOVE ACCELERATION SENSOR ASSEMBLY
(a) Disconnect the sensor connector.
(b) Remove the bolt and acceleration sensor with bracket from the instrument panel reinforcement.
-
Avoid any impact to the acceleration sensor.
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
-
The acceleration sensor removed from the vehicle must not be placed upside down.
Installation
SUSPENSION CONTROL: FRONT ACCELERATION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL ACCELERATION SENSOR ASSEMBLY