LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(e) Install a new tube connector.
NOTE: Push in the tube connector until a "click" sound is heard.
2. INSTALL LOWER FRONT SHOCK ABSORBER BRACKET SUB-ASSEMBLY LH
(a) Install the lower front shock absorber bracket sub-assembly LH to the front pneumatic shock absorber with cylinder assembly LH with the bolt.
Torque: 48 Nm (489 kgf-cm, 35 ft-lbf)
3. INSTALL FRONT PNEUMATIC SHOCK ABSORBER WITH CYLINDER ASSEMBLY LH
(a) Install the front pneumatic shock absorber with cylinder assembly LH on the vehicle by installing the 3 nuts on the suspension support side.
Torque: 67 Nm (683 kgf-cm, 49 ft-lbf)
4. INSTALL ABSORBER CONTROL ACTUATOR
(a) Check that the control rod of the front pneumatic shock absorber with cylinder assembly LH is in the position shown in the illustration.
NOTE: If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position and install the absorber
control actuator.