LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
7.
Push the START/STOP button until the vehicle is in the "IG-ON" mode, and then push and hold the Tire Pressure Warning "SET" switch for 3
seconds until the Low Tire Pressure Warning Light blinks 3 times and then turns OFF to set the tire pressure initialization.
NOTE:
Make sure that the "Tire Pressure Reset Proceeding" appears on the multi-information display. After a few seconds, the display changes to
"CHECKING" (which means the tire pressures are being measured). It is necessary for the ignition to be in the "IG-ON" mode at least 5
minutes for initialization to complete correctly.
8.
Check that the tire pressures for all 5 tires is displayed on the multi-information display.
If the tire pressure values are NOT displayed on the multi-information display, the initialization is NOT complete. Return to step 7.
NOTE:
^
Check that the tire pressure adjusted in step 6 is displayed.
^
Initialization will be completed if signals are received from all 5 tires. It takes 2 to 3 minutes to display the tire pressure data.