LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
Fluid Pressure Sensor/Switch: Service and Repair
Installation
L110F HYBRID TRANSMISSION / TRANSAXLE: OIL PRESSURE SWITCH: INSTALLATION
INSTALLATION
1. INSTALL OIL PRESSURE SWITCH
(a) Install the oil pressure switch (PB1).
(1) Install the oil pressure switch (PB1) to the valve body.
Torque: 4.4 Nm (45 kgf-cm, 39 in-lbf)
HINT: An oil pressure switch (PB1) is marked with blue paint.
(2) Connect the oil pressure switch connector.
NOTE: Make sure that the terminals are securely engaged with the oil pressure switch.
HINT: If the terminals do not engage securely, replace the transmission wire.
(b) Install the oil pressure switch (PB2).
(1) Install the oil pressure switch (PB2) to the valve body.
Torque: 4.4 Nm (45 kgf-cm, 39 in-lbf)
HINT: An oil pressure switch (PB2) is marked with blue paint.