LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-1659003.png)
(b) Install the oil strainer to the valve body with the 3 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
-
When installing the oil strainer, do not allow the wire harness to get caught between the parts.
-
When installing the oil strainer, make sure that the O-ring is not twisted.
-
Do not allow the O-ring to get jammed between the parts.
-
If a new oil strainer assembly is reinstalled, repeat turning the power switch off and on twice. DTC for the oil pressure switch system may
be output while performing this procedure, but they do not indicate malfunctions. Therefore, clear the DTCs.
-
After the oil strainer is replaced with a new one, perform the following menus: Powertrain / Hybrid Control / Utility / B1 Air Bleeding.
3. INSTALL TRANSMISSION OIL PAN SUB-ASSEMBLY
(a) Install the 2 magnets to the oil pan.
(b) Install a new gasket to the oil pan.
-
Make sure that there is no oil or foreign matter on the gasket seal surface or oil pan contact surface.
-
Install the gasket so that there is no slack in the gasket, and that the entire circumference of the seal surface is level.
-
Make sure that the 6 gasket drop prevention protrusions are set on the oil pan.
-
When tightening the oil pan, make sure that the gasket is not pinched between the gasket tightening area sleeve and the transmission seal
surface.
