LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-1716005.png)
-
Use a torque wrench with a fulcrum length of 400 mm (15.7 in.)
-
The torque value for use with SST is effective when SST is parallel to the torque wrench.
-
Tighten the bolts so that they do not interfere with the bolt holes of the mount cushions.
(g) Using SST and a 12 mm socket hexagon wrench, tighten the bolt (C).
without SST - Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
with SST - Torque: 75 Nm (765 kgf-cm, 55 ft-lbf)
NOTICE:
-
Use a torque wrench with a fulcrum length of 400 mm (15.7 in.)
-
The torque value for use with SST is effective when SST is parallel to the torque wrench.
-
Tighten the bolts so that they do not interfere with the bolt holes of the mount cushions.
(h) Tighten the 2 bolts (B).
Torque: 105 Nm (1071 kgf-cm, 77 ft-lbf)
NOTE: Make sure that the rear differential mount stopper upper and lower are not shifted or tilted.
2. INSTALL DRIVE SHAFT ASSEMBLY
(a) Install the drive shaft assembly LH and RH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Rear Drive Shaft
Assembly/Installation.
3. ADD DIFFERENTIAL OIL See: Fluid - Differential/Service and Repair
Components
DIFFERENTIAL: FRONT DIFFERENTIAL CARRIER ASSEMBLY: COMPONENTS
COMPONENTS
