LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-1731014.png)
43. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.6 Nm (57 kgf-cm, 50 in-lbf)
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
44. ADJUST PARKING BRAKE SHOE CLEARANCE See: Brakes and Traction Control/Parking Brake System/Adjustments
45. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
46. STAKE REAR AXLE SHAFT NUT LH
(a) Using a chisel and a hammer, stake the axle shaft nut.
47. STAKE REAR AXLE SHAFT NUT RH
HINT: Use the same procedures described for the LH side.
48. STABILIZE SUSPENSION See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Rear Shock
Absorber/Installation
49. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear
Lower Arm/Installation
50. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT: Use the same procedures described for the LH side.
51. TIGHTEN PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH See: Steering and Suspension/Suspension/Control
Arm/Service and Repair/Rear Upper Arm/Installation
52. TIGHTEN PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY RH
HINT: Use the same procedures described for the LH side.
53. INSTALL REAR SUSPENSION MEMBER BRACE LH
(a) Install the rear suspension member brace with the 2 bolts.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
54. INSTALL REAR SUSPENSION MEMBER BRACE RH
