RX 300 FWD V6-3.0L (1MZ-FE) (1999)
^
To install the E-Rings, follow Figure 1.
NOTE:
Slightly crimp the E-Rings to reduce the opening size. This will prevent the E-Ring from falling off when the rear hatch trim panel is replaced.
1.
Remove the 2-10 mm bolts from the Door Lock Control Assembly.
2.
Remove the Door Lock Control Assembly from the rear hatch inner panel.
3.
Add the E-Rings as indicated in Figure 1 by pulling on the ball at the end of the cable.
4.
Replace the Door Lock Control Assembly.
5.
Replace the 2-10 mm bolts.
NOTE:
Torque Requirements: 5.5 Nm (56 kgf.cm, 49 in.lbf)