RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Rear
REMOVAL
1. DISCONNECT SPEED SENSOR CONNECTOR
a. Remove the rear seat, scuff plate and rear seat side garnish.
b. Disconnect the speed sensor connector, and pull out the sensor wire harness with the grommet.
2. REMOVE SPEED SENSOR
a. Remove the 2 clamp bolts holding the sensor wire harness to the body and shock absorber.
Torque: 5.0 Nm (55 kgf.cm, 48 inch lbs.)
b. Remove the bolt, O-ring (2WD) and speed sensor from the axle carrier.
Torque: 2WD: 8.0 Nm (82 kgf.cm, 71 inch lbs.) 4WD: 20 Nm (200 kgf.cm, 14 ft. lbs.)
INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, CHECK SPEED SENSOR SIGNAL