RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Parking Brake Pedal: Service and Repair
REMOVAL
1. REMOVE LOWER NO.1 FINISH PANEL
2. RELEASE PARKING BRAKE PEDAL
3. DISCONNECT PARKING BRAKE SWITCH CONNECTOR AND CLAMP
4. REMOVE PARKING BRAKE PEDAL ASSEMBLY
Remove the 3 nuts and parking brake pedal assembly.
Torque: 39 Nm (400 kgf.cm, 29 ft. lbs.)
5. DISCONNECT PARKING BRAKE WIRE
Remove the clip and disconnect the parking brake wire.
6. REMOVE PARKING BRAKE SWITCH
Remove the screw and parking brake switch.
7. REMOVE PEDAL PAD FROM PARKING BRAKE PEDAL
INSTALLATION
Installation is in the reverse order of removal.