RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Cabin Temperature Sensor / Switch: Testing and Inspection
1. REMOVE THESE PARTS:
a. Front door scuff plate LH
b. Cowl side trim LH
2. REMOVE ROOM TEMPERATURE SENSOR
a. Remove the 2 lower finish panel set bolts.
b. Pull out the lower finish panel.
c. Disconnect the connector and aspirator hose.
d. Release the 2 claws and pull out the sensor.
3. INSPECT ROOM TEMPERATURE SENSOR CIRCUIT
4. INSTALL ROOM TEMPERATURE SENSOR
5. INSTALL LOWER FINISH PANEL
6. INSTALL THESE PARTS:
a. Cowl side trim LH
b. Front door scuff plate LH