RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Compressor Clutch: Service and Repair
Removal and Installation
REMOVAL
1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES
2. STOP ENGINE
3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY
4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
5. REMOVE DRIVE BELT
6. DISCONNECT DISCHARGE AND SUCTION HOSES
Remove the bolt, nut and disconnect the both hoses.
NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.
7. REMOVE GENERATOR
a. Disconnect the generator connector.
b. Remove the nut, and disconnect the generator wire.
c. Disconnect the wire harness from the clamp.
d. Remove the pivot bolt, adjusting lock bolt and generator.
8. REMOVE COMPRESSOR
a. Disconnect the connector.
b. Disconnect the wire harness clamp.
c. Remove the 2 bolts, nut and drive belt adjusting bar bracket.