RX 300 FWD V6-3.0L (1MZ-FE) (1999)
6. REMOVE DELIVERY PIPES AND INJECTORS
NOTE:
-
Be careful not to drop the injectors when removing the delivery pipes.
-
Pay attention to put any hung load on the injector to and from the side direction.
a. Remove the 5 bolts and delivery pipes together with the 6 injectors and fuel pipe.
b. Remove the 4 spacers from the intake manifold.
c. Pull out the 6 injectors from the delivery pipes.
d. Remove the 2 O-rings and 2 grommets from each injector.
INSTALLATION
1. INSTALL INJECTORS AND DELIVERY PIPES
a. Install new insulator and grommet to each injector.
b. Apply a light coat of spindle oil or gasoline to 2 new O-rings and install them to each injector.
c. Apply a light coat of spindle oil or gasoline on the place where a delivery pipe touches an O-ring of the injector.
d. While turning the injector clockwise and counterclockwise, push it to the delivery pipes. Install the 6 injectors.
e. Position the injector connector outward.