RX 300 FWD V6-3.0L (1MZ-FE) (1999)
NOTE:
-
Installation of the connector is done after the sensor assembly has been installed.
-
Make sure the sensor assembly is installed with the specified torque.
-
If the sensor assembly has been dropped, or there cracks, dents or other defects in the case, bracket connector, replace the sensor assembly
with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installing, shake the sensor assembly to check that there is no looseness.
-
Check there is no interference with the shift cable.
2. INSTALL NO.1 BRACE
a. Install air ducts.
b. Install the No.1 brace with the 3 bolts and 2 nuts.
c. Install the shift control cable bracket with the 2 nuts.