RX 300 FWD V6-3.0L (1MZ-FE) (1999)
/Page-1871005.png)
-
Make sure that the side airbag assembly is installed with the specified torque.
-
If the side airbag assembly has been dropped, or there are cracks, dents or other defects in the case or connector, replace the side airbag
assembly with a new one.
-
When installing the side airbag assembly, take care it is not pinched between other parts.
2. INSTALL SEAT CUSHION ASSEMBLY
a. Install the wire harness of the side airbag assembly to the reclining adjuster inside cover as shown in the illustration.
NOTE: Be careful not to damage the airbag wire harness.
b. Install the 3 screws and reclining adjuster inside cover.
c. Install the seat cushion assembly and 4 bolts.
Torque: 18 Nm (183 kgf.cm, 13 ft.lbf)
d. Install the wire harness of the side airbag assembly to the seat cushion assembly.
NOTE: Be careful not to damage the airbag wire harness.
e. Install the front seat cushion inner shield and 3 screws.
f.
Install the front seat cushion shield and front power adjuster shield.
g. Install the 2 switch knobs.
3. INSTALL SEATBACK COVER (W/PAD)
