RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Evaporator Temperature Sensor / Switch: Testing and Inspection
1. REMOVE INSTRUMENT PANEL
2. REMOVE EVAPORATOR TEMPERATURE SENSOR
a. Pull out the air duct from A/C unit.
b. Remove aspirator set bolt.
c. Disconnect the connector and connector clamp.
d. Using a screwdriver, pull out the sensor.
HINT: Tape the screwdriver tip before use.
e. Release the 2 claws and remove the sensor from bracket plate.
3. INSPECT EVAPORATOR TEMPERATURE SENSOR
4. INSTALL EVAPORATOR TEMPERATURE SENSOR
5. INSTALL INSTRUMENT PANEL